Tile Adhesive Type 3
Product Description
Suitable for
Material & Area
- Large format Vitrified tiles.
- Granite, marble and all types of stones.
- Internal & External floor and walls.
- Residential, commercial, industrial.
- Swimming pool and water bodies
Substrate
- Cement mortar beds
- Cement based plaster / Concrete / Screed / Terrazzo / Brick / Block /Concrete Masonry
- Tile on Tile
- Cement based self leveling screed
- Water proofing products
- Fibre cement slabs
Installation
Surface Preparation
Surface should be structurally sound levelled & properly cured. It should be free from dirt, oil, grease, lose peeling paint, concrete sealer or curing compound.
Pre-wet or dampen the concrete surface with fresh water before application.
Mixing
Take 5-6 litres of potable water for every 20 kg of adhesive.
Gradually mix 20 kg dry mix product with water (not vice versa) while continuously mixing it with a low speed mixer.
Mix thoroughly for 2-3 minutes or until you achieve a uniformly coloured, smooth mixture, which is lump free paste in workable consistency . Add additional water, if necessary, but do not exceed the maximum specified amount.
Allow the mixed product to settle for 4-5 minutes without stirring.
Remix for 15 seconds just before using.
Application
The adhesive needs to be applied with a flat side of the trowel using a scrapping motion.
Additional mortar should be then applied with the notched edge of the trowel.
For large size tiles with sides > 2 feet, apply additional adhesive to the back of the tile surface with the flat side of the trowel.
Occasionally check to inspect tiles are properly stuck. If the adhesive seems to be non-sticky, remove the existing and replace with fresh adhesive. Use a rubber mallet to tap the tile and ensure it is fully bedded in the adhesive.
Cleaning
Clean any excess adhesive from the tiles surfaces and grout lines immediately with a damp sponger or cloth.
Grouting
Grouting should be carried out after 24 hours of tilling.
Features & Benifits:
Quick and ready to use
Easy to use and economical
Superior adhesion
Better workability
For internal walls and floors
Suitable for ceramic and vitrified tiles
No curing required
Technical Details
Conforms to IS 15477:2019 Type 3‘T’; EN 12004 C2T
| PARAMETERS | RESULTS |
| Colour | Grey |
| Bulk Density | 1.55-1.65 Kg/Ltr |
| Pot Life | > 2 Hours |
| Open Time | 20 Minutes approx |
| Adjustability | 20 Minutes approx |
| Final Setting Time | 24 Hours |
| Max, Bed Thickness | 15 mm |
| Time to Light Foot Traffic | 16-24 Hours |
| Ready For Grouting | 24 Hours |
| Ready For Use | 14 Days |
I’m Interested. Tell me More
Head Office Pune
1, Samarth Tarrace, Near Ganpati Chowk, Near Air Force Station gate, Viman Nagar, Pune 411014.
For Mumbai Enquiry
Contact Mr. Shailendra Tiwari
- +91 84548 41354
sales@envoplast.in
Phone
+91 9960383838 | +91 9823025484 | +91 35918083
