At R. D. Ventures we strongly believe in the values of recycle, reuse and regenerate and therefore we present to you EnvoPlast - a ready mix cement plaster. EnvoPlast contains more than 75% of waste from different industries like processed waste sand and fly ash making it a green material.

For external and internal walls:


  • Enhanced with Suitable Polymers.
  • Easy to Apply.
  • Saves Money.
  • Saves Time.
  • Super Finish.
  • No Silt.
  • Least Rebound.
  • Assured Quality and Durability.

EnvoPlast is a ready mix cement plaster with high quality additives. It can be used on both inner and outer walls. It can also be used efficiently on brick, block, stone walls as well as on concrete surfaces. EnvoPlast gives even surface on which tiling can also be done faster and very efficiently.

EnvoPlast is used in place of traditional plastering, it is a convenient and easy-to-use plaster that is stronger, looks smooth and binds better to its base. Prepared with a mix of special binders and additives, EnvoPlast is water resistant with high quality and sustainability. Walls with EnvoPlast have lesser chances of developing cracks in comparison to conventional methods.

EnvoPlast is a plaster made by the right composition of raw materials. It passes through stringent quality controls and made with graded sand which enhances the durability. EnvoPlast is not only convenient for use but it also maintains cleanliness at work place and considerably reduces wastage than conventional methods at the time of execution.


EnvoPlast is available in 50 Kg bags. At R. D. Ventures we strongly believe in protecting our environment and hence offer our clients a packaging option of used bags of 40 Kg.

Shelf life:

EnvoPlast can be safely stored up to 6 months if kept in a dry place above the ground level and covered well. Hard material should not be used for covering.

Technical Description:

  Appearance   Grayish granular powder
  Main Binder   Portland Cement
  Aggregate   Graded Sand
  Additives   Water soluble additives for better efficiency, binding, water retaining and strength
  Maximum Aggregate Size   Less than 2.36 mm
  Bulk Density   1.2 - 1.6 Kg/liter unit
  Compressive Strength (mpa)   More than 5 in 28 days
  Coverage   0.16-0.23 Kg/sq.f./mm**
  Thickness of   Layer 6-12 mm
  Pot Life   1-2 hours
  Proportion of Water (%)   15%-20% of the weight

Mixing Method:

Prepare the plaster by mixing 7-10 liters of water per every 50 Kg bag of EnvoPlast. Use of mechanical mixer-electrical stirrer is recommended for better results. Mixing should be done for 5-10 minutes depending upon the speed of mixing equipment. When the mixture is prepared, leave it for 5 minutes and mix it once again just before use. Do not add any water to the mixture at this point of time. Hard and set plaster should not be mixed again. The correct ratio of water and EnvoPlast is essential for best results.

Preparation of Surface:

The surface should be free of dust, grease etc., else it will affect binding. If the surface is dry, it should be moistened with clean water.

Applying on the surface:

The mixture should be applied within 1-2 hour of preparation. If the concrete surface is smooth and dense, it's recommended that the surface is made rough with a comb for better sticking of the plaster layer. EnvoPlast should be applied with hand and care should be taken that it doesn't have direct exposure to sunlight, wind and rain during it's application.


In normal weather, EnvoPlast doesn't need curing for first 24 hours. After the plaster is completely dry, curing should be done 2-3 times for 2-3 days. In abnormal weather conditions, curing for 5-7 days is required.

Methodology for Plastering

EnvoPlast Brochure

IGBC certificate  

Test Report